Water dispenser filter

---

Product structure details

What is what dispenser filter?

Top Water Tank:Capacity:12L;enough for home and daily use. It is easy to add water,and also easy to clean.

Electrical protection valve for bamp:This valve is very important for bamp work reliable and effectively.There is one small storage at the bottom of it. when the water in the storage is under of one fixed capacity, it will send request to bamp and then pamp will work and the water will flow from the top tank to the cartridge. and when the water in storage is much than fixed capacity,it will notify pump and then the pump will stop working,and the water willnot flow from the top tank.

Pump:Voltage:24V;

Transformer for pump:power in:220V,power out:24V;It will ensure the pump wrok with right voltage;

PP cartridge:These range in size from 30 microns down to 1 micron. This filter works on the larger particles in the water. The finer the pre filter the faster it will clog up with impurities. You will want to protect the pre-carbon in a thin film composite or TFC system from fouling by sediment. A 5 to 10 micron pre filter is best suited for residential systems. In a cellulose tri-acetate or CTA system the sediment filter is all that stands between the incoming tap water and your expensive membrane. It works as the first line of defense for both types of systems. If you live in an area that has a lot of sediment than you should change this filter more often, typically it is sufficient to change it every 6 months.

CTO cartridge:it will remove the chlorine before it comes in contact with your membrane this will extend the life of a TFC membrane. If used on a CTA system it will cause the membrane to fail. The reason is because a CTA needs chlorine in the water to protect it from bio fouling. This filter should be replaced every 6 months.

UF cartridge:here write some details about this cartridge.

Post carbon cartridge:This is a polishing filter that removes taste and orders. It usually contains smaller more fine carbon than the coarser pre carbon. Most post carbon filters are encapsulated or are in the form of a cartridge. What's inside the filter is simply coconut shells that are burned at 2500 degrees in a furnace. This gives the water a very pleasant taste and should be replaced every 6 months.

top tank of dispenser: storing the filtered water.capacity:6L;

Mechinical Floating vlave: to protect the water leakage from the dispenser storage.

simple speaking,water dispenser filter means water dispenser with filter inside.However,Our machine does not like other similar POU dispenser on the markets.For regular POU machine,the water feed is from the tube which conntect with water tap.So it must be put where there is water supply(water tap).such as it cannot be put in the living room,bedroom of your home easily.and also the normal POU machine use mechincal valve and it is very easy to leakage and distroy your house.

Hot water tank of dispenser: 1.8L capacity.

Cold water tank of dispenser:1.1L capacity.

Hot water tap: supply hot water to you.

Cold water tap: supply cold water to you.